Take the BARBI fitting required and the GLADIATOR end joint of the corresponding diameter.	Place the rubber joint at the end of the thread.	Place the ring onto the pipe ,in such a way that the extreme point of the greater diameter of the ring remains next to the end of the pipe.	The pipe has to be calibrated in the same way as would be done with a BARBI Cross-Linked pipe.
GLADIATOR pipe is assembled, once being calibrated on the fitting.	With the help of our Barbi tool, slide the ring down until the end.

NOTE

1. Replace BARBI classical ring with the special BARBI GLADIATOR rings.
2. Add the end joint to avoid corrosions caused by the contact between the aluminium of the pipe and the brass of the fittings.
3. Substitute the classical BARBI cradles , used for cross-linked polyethylene pipes with the special GLADIATOR cradles.
4. Proceed to assembly exactly in the same way as with the traditional BARBI system.